Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
bootcamp2017paris:camelia [2017/09/13 12:45]
camishan 		bootcamp2017paris:camelia [2017/09/13 12:48]
camishan
Line 32: Line 32:
  
 **Settings** **Settings**
-I used the same settings as in the post, even though I have used PLA filament instead of TPU. The print was quite good, the only problem was that unfortunately,​ the snaps didn't snap together. Maybe, due to the high temperature setting (normally I would use 190C for PLA filament), it is possible that the female pieces have slightly enlarged. However, to counteract this issue, I intend to scale the female pieces, to reduce to ~80%.  
-  
  
 +I used the same settings as in the post, even though I have used PLA filament instead of TPU. The print was quite good, the only problem was that unfortunately,​ the snaps didn't snap together. Maybe, due to the high temperature setting (normally I would use 190ºC for PLA filament), it is possible that the female pieces have slightly enlarged. However, to counteract this issue, I intend to scale the female pieces, to reduce to ~80%.
 +
 +Infill: 75%
 +Layer Height: 0.2mm
 +Temp: 220ºC
 +Speed while extruding: 80 mm/s 
 +Speed while travelling: 150 mm/s.