Link to this comparison view

Both sides previous revision Previous revision
bootcamp2017paris:camelia [2017/09/13 12:48]
camishan
bootcamp2017paris:camelia [2017/09/13 12:49] (current)
camishan
Line 35: Line 35:
 I used the same settings as in the post, even though I have used PLA filament instead of TPU. The print was quite good, the only problem was that unfortunately,​ the snaps didn't snap together. Maybe, due to the high temperature setting (normally I would use 190ºC for PLA filament), it is possible that the female pieces have slightly enlarged. However, to counteract this issue, I intend to scale the female pieces, to reduce to ~80%. I used the same settings as in the post, even though I have used PLA filament instead of TPU. The print was quite good, the only problem was that unfortunately,​ the snaps didn't snap together. Maybe, due to the high temperature setting (normally I would use 190ºC for PLA filament), it is possible that the female pieces have slightly enlarged. However, to counteract this issue, I intend to scale the female pieces, to reduce to ~80%.
  
-Infill: 75% +  * Infill: 75% 
-Layer Height: 0.2mm +  ​* ​Layer Height: 0.2mm 
-Temp: 220ºC +  ​* ​Temp: 220ºC 
-Speed while extruding: 80 mm/s  +  ​* ​Speed while extruding: 80 mm/s  
-Speed while travelling: 150 mm/s.+  ​* ​Speed while travelling: 150 mm/s.