| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
fabricademy2017:classes:wearables2 [2017/11/20 19:31] becky_stewart |
fabricademy2017:classes:wearables2 [2017/11/22 16:09] becky_stewart |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| **Prep for Class** | **Prep for Class** | ||
| - | Install the Arduino software (IDE) on your computer or test that you can use the new Web Editor for Arduino. Upload the Blink sketch. See [[http://adventuresinarduinobook.com/the-adventures/adventure-1-setting-up-your-arduino/|this tutorial]] for guidance on installing the IDE or [[https://www.arduino.cc/en/Guide/HomePage|this page]] for info about both the IDE and Web Editor. | + | Install the Arduino software (IDE) on your computer or test that you can use the new Web Editor for Arduino. Upload the Blink sketch. See [[http://adventuresinarduinobook.com/the-adventures/adventure-1-setting-up-your-arduino/|this tutorial]] for guidance on installing the IDE or [[https://www.arduino.cc/en/Guide/HomePage|this page]] for info about both the IDE and Web Editor. Doesn’t matter whether an Uno, Lilypad or some other Arduino board. |
| + | |||
| + | Prepare a pressure or stretch sensor. | ||
| + | |||
| + | Have a multimeter handy. | ||
| **Class Outline** | **Class Outline** | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International