| Both sides previous revision Previous revision | |||
|
fabricademy2017:students:brigitte.kock:week10 [2017/12/12 15:04] brigitte.kock |
fabricademy2017:students:brigitte.kock:week10 [2017/12/12 15:05] (current) brigitte.kock |
||
|---|---|---|---|
| Line 45: | Line 45: | ||
| {{ :fabricademy2017:students:brigitte.kock:the_silicone_does_not_go_out_of_the_mould.jpg |}} | {{ :fabricademy2017:students:brigitte.kock:the_silicone_does_not_go_out_of_the_mould.jpg |}} | ||
| - | So in the end I took it out with brute force, which unfortunately damaged both the mould and the silicone. What you can see in the first picture below is that the silicone went right through the mould | + | So in the end I took it out with brute force, which unfortunately damaged both the mould and the silicone. What you can see in the first picture below is that the silicone went right through the mould, so the infill density will need to be even higher? |
| {{:fabricademy2017:students:brigitte.kock:silicon_went_all_the_way_through_the_mould.jpg?500|}} | {{:fabricademy2017:students:brigitte.kock:silicon_went_all_the_way_through_the_mould.jpg?500|}} | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International