Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
fabricademy2017:students:cheung:week_10_-_soft_robotics [2018/03/02 15:58]
wei-ying.cheung [The Process]
fabricademy2017:students:cheung:week_10_-_soft_robotics [2018/03/03 16:37]
wei-ying.cheung
Line 3: Line 3:
 This week I designed and 3D printed a mould similar to the soft gripper mould in the presentation,​ which I used to create a soft gripper out of silicone rubber. I attempted to inflate the gripper but because of a tear in the side of the gripper, it did not inflate much. To download the file for the mould, visit: [[https://​oscircularfashion.herokuapp.com/​project/​-L6SSksUvEhCAW8dIZ4v|https://​oscircularfashion.herokuapp.com/​project/​-L6SSksUvEhCAW8dIZ4v]] This week I designed and 3D printed a mould similar to the soft gripper mould in the presentation,​ which I used to create a soft gripper out of silicone rubber. I attempted to inflate the gripper but because of a tear in the side of the gripper, it did not inflate much. To download the file for the mould, visit: [[https://​oscircularfashion.herokuapp.com/​project/​-L6SSksUvEhCAW8dIZ4v|https://​oscircularfashion.herokuapp.com/​project/​-L6SSksUvEhCAW8dIZ4v]]
  
-===== The Process ​=====+===== First experiment ===== 
 + 
 +Firstly, as a group we explored a different inflatable design - a pneumatic wrist brace. We used Adriana'​s pre-designed template, as below: 
 + 
 +{{:​fabricademy2017:​students:​cheung:​soft_robotics:​wrist_template.jpg?​nolink&​600x412|wrist_template.jpg}} 
 + 
 +We cut this design in the vinyl cutter, the outer part twice in heat transfer vinyl, and the inner part once in baking paper. After cutting, we layered the vinyl pieces on top of each other with the baking paper in the middle. We then used the heat press (temperature 110 degrees, 15 seconds) to seal the vinyl pieces together, leaving the baking paper part unsealed - thereby forming the air channel. After this, we added ties through the holes and inflated it with the pump. 
 + 
 +{{:​fabricademy2017:​students:​cheung:​soft_robotics:​pneumatic_wrist_bracelet.png?​nolink&​800x359}} 
 + 
 +When trying out the inflated wrist brace, I found that it provided firm support and protection around the wrist. 
 + 
 +===== The Soft Gripper ​=====
  
 I used the design shown in the presentation to create a mould in Fusion 360 that had rounded corners at the centre and pointier ends on the arms. I thought that the rounded corners might make it easier to remove from the mould and decrease the likelihood of tearing. I then 3D printed the mould using normal PLA. I used the design shown in the presentation to create a mould in Fusion 360 that had rounded corners at the centre and pointier ends on the arms. I thought that the rounded corners might make it easier to remove from the mould and decrease the likelihood of tearing. I then 3D printed the mould using normal PLA.