| Both sides previous revision Previous revision | |||
|
fabricademy2017:students:detoledomotta.naiadelara:week_2 [2017/10/10 14:11] naiadelara.de-toledo-motta |
fabricademy2017:students:detoledomotta.naiadelara:week_2 [2017/10/10 14:12] naiadelara.de-toledo-motta |
||
|---|---|---|---|
| Line 25: | Line 25: | ||
| This section of the documentation will showcase step-by-step how do we get from zero to the final product. | This section of the documentation will showcase step-by-step how do we get from zero to the final product. | ||
| - | == STEP 1 : == | + | == STEP 1 : == |
| Scanning of the body of body part with the 360 fusion Scanner. | Scanning of the body of body part with the 360 fusion Scanner. | ||
| - | **1.0 **{{:fabricademy2017:students:naiade:img-20171010-wa0003_1_.jpg?nolink&150x267|img-20171010-wa0003_1_.jpg}}** 2.0**{{:fabricademy2017:students:naiade:22425816_10214839295283015_1861380125_o.jpg?nolink&200x267|22425816_10214839295283015_1861380125_o.jpg}} | + | **1.0 **{{:fabricademy2017:students:naiade:img-20171010-wa0003_1_.jpg?nolink&150x267|img-20171010-wa0003_1_.jpg}}** 2.0**{{:fabricademy2017:students:naiade:22425816_10214839295283015_1861380125_o.jpg?nolink&200x267|22425816_10214839295283015_1861380125_o.jpg}} |
| Two possible techniques used: | Two possible techniques used: | ||
| Line 45: | Line 45: | ||
| __**STEP 3:**__ From Meshmixer to Slicer, the image is configurated to be cutted in slices. In this software we can input the configuration about sizes, of the slices and boad to be cuted on laser cutter. | __**STEP 3:**__ From Meshmixer to Slicer, the image is configurated to be cutted in slices. In this software we can input the configuration about sizes, of the slices and boad to be cuted on laser cutter. | ||
| - | This software also allows you to chose different techniques to cut the solid image from Meshmixer. In my case, as a environmental scientist I chose the method that I would use the least material possible. As you can see in the picture bellow I chose Radial Slices. | + | This software also allows you to chose different techniques to cut the solid image from Meshmixer. In my case, as a environmental scientist I chose the method that I would use the least material possible. As you can see in the picture bellow I chose Radial Slices. I used 2x Cardboard plates of 1000x600mm. |
| {{:fabricademy2017:students:naiade:22396824_10214839291122911_2030465176_o.jpg?nolink&350x263|22396824_10214839291122911_2030465176_o.jpg}} | {{:fabricademy2017:students:naiade:22396824_10214839291122911_2030465176_o.jpg?nolink&350x263|22396824_10214839291122911_2030465176_o.jpg}} | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International