| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
fabricademy2017:students:julie.taris:final_projectpresentation [2018/06/30 17:08] julie_taris |
fabricademy2017:students:julie.taris:final_projectpresentation [2018/06/30 17:13] julie_taris |
||
|---|---|---|---|
| Line 50: | Line 50: | ||
| - | ==3/Heat Sealing Laser Engraver Hood Pattern with Flex Polyurethane== | + | ==4/Heat Sealing Laser Engraver Hood Pattern with Flex Polyurethane== |
| Position the 2 layers of polyurethane, the faces with the film subsequently removed must be on the outside. the shiny faces inside face to face. | Position the 2 layers of polyurethane, the faces with the film subsequently removed must be on the outside. the shiny faces inside face to face. | ||
| Once the acrylic support is laid on the polyurethane layers, position the weights all around. | Once the acrylic support is laid on the polyurethane layers, position the weights all around. | ||
| Line 65: | Line 65: | ||
| - | 4/Air Pump Circuit 12V | + | ==5/Air Pump Circuit 12V== |
| * Serial Controlled Motor Driver | * Serial Controlled Motor Driver | ||
| * Silicone air tube 8mm | * Silicone air tube 8mm | ||
| Line 78: | Line 78: | ||
| {{:fabricademy2017:students:julie.taris:visoule-project-fabricademy-julie-taris.jpg?200x200|}} | {{:fabricademy2017:students:julie.taris:visoule-project-fabricademy-julie-taris.jpg?200x200|}} | ||
| - | + | ==6/Inflate== | |
| - | 5/Inflate | + | Remove the outer film from the polyurethane. |
| + | I use a 3 way medical valve. | ||
| {{:fabricademy2017:students:julie.taris:visoule-project-fabricademy-julie-taris-inflatable_2_.jpg?200x200|}} | {{:fabricademy2017:students:julie.taris:visoule-project-fabricademy-julie-taris-inflatable_2_.jpg?200x200|}} | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International