| Both sides previous revision Previous revision | |||
|
fabricademy2017:students:luis.dulanto:week13 [2018/07/22 20:30] luis_dulanto |
fabricademy2017:students:luis.dulanto:week13 [2018/07/22 20:40] luis_dulanto |
||
|---|---|---|---|
| Line 156: | Line 156: | ||
| So at this point, I got the design of the inflatable ready for being flattened. | So at this point, I got the design of the inflatable ready for being flattened. | ||
| + | Then I loaded the model on SlicerForFusion360 (from Autodesk). | ||
| - | <grid> | + | I selected folded panels and exported the pieces, first with tongues and with seams. The first one, was for creating a mockup, and the second one, was for getting the plastic pieces that were going to be joined for building the inflatable. |
| - | <col sm="1"> </col> | + | |
| - | <col sm="11"> | + | |
| - | {{:fabricademy2017:students:luis.dulanto:w13d1.png?600}} | + | |
| - | {{:fabricademy2017:students:luis.dulanto:w13d2.png?600}} | + | |
| - | {{:fabricademy2017:students:luis.dulanto:w13d3.png?600}} | + | |
| - | {{:fabricademy2017:students:luis.dulanto:w13d4.png?600}} | + | |
| - | </col> | + | |
| - | </grid> | + | |
| - | + | ||
| - | Then I loaded the model on Slicer. Selected folded pannels and exported the pices, first with tongues and with seams. The first one, was for creating a mock up, and the second one, was for getting the plastic pieces that were going to be joined for bulding the inflatable. | + | |
| <grid> | <grid> | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International