| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
fabricademy2017:students:luis.dulanto:week2 [2018/02/15 22:56] luis_dulanto |
fabricademy2017:students:luis.dulanto:week2 [2018/02/15 23:01] luis_dulanto |
||
|---|---|---|---|
| Line 320: | Line 320: | ||
| </grid> | </grid> | ||
| - | For milling the pieces, I turned on the shopbot milling machine and the spinning tool, and fixed the MDF board to the machine witg some holders; After that, I clicked on reset on the techpendant and calibrated the machine at Z direction, this was done with a conductive plate and and scissors, and calibrated it in the XY plane, this was done atumatically by clicking on the calibrate XY button; then, I loaded the drilling toolpath on the shopbot software, for making the holes where I was going to put the screws that fixed the MDF board to the machine; I clicked on the start button and then clicked on start on the techpendant, once I did this the machine started to make the holes. So I used dose holes for fixing the board with screws and then I loaded the tootlpath of the smaller pieces to be milled and hitted on start at the software and once again I clicked start with the techpendant and repetated those steps until all the pieces where milled. | + | For milling the pieces, I turned on the shopbot milling machine and the spinning tool, and fixed the MDF board to the machine witg some holders; After that, I clicked on reset on the techpendant and calibrated the machine at Z direction, this was done with a conductive plate and and scissors, and calibrated it in the XY plane, this was done atumatically by clicking on the calibrate XY button; then, I turned on the air compressor, and loaded the drilling toolpath on the shopbot software, for making the holes where I was going to put the screws that fixed the MDF board to the machine; I clicked on the start button and then clicked on start on the techpendant, once I did this the machine started to make the holes. So I used dose holes for fixing the board with screws and then I loaded the tootlpath of the smaller pieces to be milled and hitted on start at the software and once again I clicked start with the techpendant and repetated those steps until all the pieces where milled. |
| <grid> | <grid> | ||
| Line 371: | Line 371: | ||
| ===== Building my own mannequin ===== | ===== Building my own mannequin ===== | ||
| + | For building my mannequin, I had to sand all the pieces and then with the aid of Alexandra, Carlos and my tutor I built the mannequin. | ||
| <grid> | <grid> | ||
| <col sm="1"> </col> | <col sm="1"> </col> | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International