Both sides previous revision Previous revision | Next revision Both sides next revision | ||
fabricademy2017:students:nuria.robles:week_11 [2017/12/12 13:49] nuriafablab_gmail.com |
fabricademy2017:students:nuria.robles:week_11 [2018/02/15 12:07] nuriafablab_gmail.com |
||
---|---|---|---|
Line 8: | Line 8: | ||
Level Advanced : Pneumatic, digitally controlled system | Level Advanced : Pneumatic, digitally controlled system | ||
+ | |||
+ | ====== Pneumatic Wrist Brace ====== | ||
+ | |||
+ | First of all I downloaded the design to cut on the vynil cutter, the material I used was an urethane. | ||
+ | |||
+ | I cut the 2 mirrored pieces . Then I cut a piece of baking paper a little bit smaller than the urethane one. This will avoid the 2 urethane pieces stick to each others. | ||
+ | |||
+ | Then I did iron the 2 pieces with a protection sheet to avoid the urethane sticks to the iron. | ||
+ | |||
+ | {{ :fabricademy2017:students:nuria.robles:soft_robotics:corteypegado_de_vinilo_sm.png?nolink&600x650 }} | ||
We started with the pneumatic wrist brace, after getting all the materials | We started with the pneumatic wrist brace, after getting all the materials |