Both sides previous revision Previous revision | Next revision Both sides next revision | ||
bootcamp2017paris:camelia [2017/09/13 12:39] camishan |
bootcamp2017paris:camelia [2017/09/13 12:45] camishan |
||
---|---|---|---|
Line 31: | Line 31: | ||
{{:bootcamp2017paris:20170912_195203.jpg?200 |}} | {{:bootcamp2017paris:20170912_195203.jpg?200 |}} | ||
+ | **Settings** | ||
+ | I used the same settings as in the post, even though I have used PLA filament instead of TPU. The print was quite good, the only problem was that unfortunately, the snaps didn't snap together. Maybe, due to the high temperature setting (normally I would use 190C for PLA filament), it is possible that the female pieces have slightly enlarged. However, to counteract this issue, I intend to scale the female pieces, to reduce to ~80%. | ||
+ | |||