| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
fabricademy2017:students:anamaria.martinlopez:week8 [2018/06/10 12:07] anamaria.martinlopez |
fabricademy2017:students:anamaria.martinlopez:week8 [2018/06/10 12:20] anamaria.martinlopez |
||
|---|---|---|---|
| Line 23: | Line 23: | ||
| **{{ :fabricademy2017:students:anamaria.martinlopez:week_8:aguja.png?nolink&400x200 }}** | **{{ :fabricademy2017:students:anamaria.martinlopez:week_8:aguja.png?nolink&400x200 }}** | ||
| - | **We have to change the base and leave a gap so that the needle can penetrate the fabric, we cut a mini frame in the laser and some small pieces to give it height.** | + | **I have to change the base and leave a space so that the needle can penetrate the fabric, I cut a mini frame in the laser and some small pieces to give it height.** |
| **Use DM of 3mm** | **Use DM of 3mm** | ||
| Line 34: | Line 34: | ||
| **{{ :fabricademy2017:students:anamaria.martinlopez:week_8:img_0422.jpg?nolink&800x600 |img_0422.jpg}}** | **{{ :fabricademy2017:students:anamaria.martinlopez:week_8:img_0422.jpg?nolink&800x600 |img_0422.jpg}}** | ||
| - | **Then we print a new support for the needle.** | + | **Then I printed a new needle holder.** |
| - **Design in Rhinoceros with the curves tool** | - **Design in Rhinoceros with the curves tool** | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International