| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
fabricademy2017:students:cheung:week_10_-_soft_robotics [2018/02/21 17:44] wei-ying.cheung |
fabricademy2017:students:cheung:week_10_-_soft_robotics [2018/02/21 17:50] wei-ying.cheung |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Week 11: Soft robotics ====== | ====== Week 11: Soft robotics ====== | ||
| - | This week I designed and 3D printed a mould similar to the soft gripper mould in the presentation, which I used to create a soft gripper out of silicone rubber. I inflated the gripper and | + | This week I designed and 3D printed a mould similar to the soft gripper mould in the presentation, which I used to create a soft gripper out of silicone rubber. I attempted to inflate the gripper but because of a tear in the side of the gripper, it did not inflate well. |
| ===== The Process ===== | ===== The Process ===== | ||
| Line 34: | Line 34: | ||
| {{:fabricademy2017:students:cheung:soft_robotics:inflate_1.jpg?nolink&800x539|inflate_1.jpg}} | {{:fabricademy2017:students:cheung:soft_robotics:inflate_1.jpg?nolink&800x539|inflate_1.jpg}} | ||
| + | |||
| + | {{:fabricademy2017:students:cheung:soft_robotics:tear.jpg?nolink&800x600}} | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International