This is an old revision of the document!
PLACE: Onl'Fait, Geneva
DATE: 11/01/2018
PEOPLE: Cristina, Stefano
STEP 1
I built a simple pressure sensor to be attached to a wrist. The input is the wrist movement, the output the behavior of a LED.
MATERIAL
- Velostat
- conductive fabric
- conductive thread
- sello tape
- Lilypad
- LED
- resistance
CREDITS
STEP 2
PREPARATION
The preparation of the sensor is very simple, it took me about 10 minutes to build it.
TEST
I tested the sensor by using a multimeter and measuring the resistance.
NOTES
STEP 3
CIRCUIT
I used the same circuit that I built for the exercise E-textiles and wearables I (week 5): the components are a Lilypad, a resistance, a LED.
NOTES
STEP 4
CODE
I used the same code that I wrote for the exercise E-textiles and wearables I (week 5). The objective is to accelerate the blinking rate of the LED depending on the wrist position. I just had to recalibrate the threshold value based on the sensor value.
NOTES
STEP 5
RESULTS
The sensor worked quite well.
NOTES
It would be interesting to build a sensor for each finger and assign more threshold values associated to different behaviours.