| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
fabricademy2017:students:detoledomotta.naiadelara:week_11 [2017/12/12 14:26] naiadelara.de-toledo-motta |
fabricademy2017:students:detoledomotta.naiadelara:week_11 [2017/12/12 14:26] naiadelara.de-toledo-motta [Step 1: Design] |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| Fusion 360 design of a 3D molde. Two moldes were desined to build up a half of the fish; Positive and Negative. | Fusion 360 design of a 3D molde. Two moldes were desined to build up a half of the fish; Positive and Negative. | ||
| - | {{:fabricademy2017:students:detoledomotta.naiadelara:untitled.png?nolink&500x281}} {{:fabricademy2017:students:detoledomotta.naiadelara:untitled2.png?nolink&500x281}} | + | {{:fabricademy2017:students:detoledomotta.naiadelara:untitled.png?nolink&500x281}}{{:fabricademy2017:students:detoledomotta.naiadelara:untitled2.png?nolink&500x281}} |
| === Step 2: 3D Print === | === Step 2: 3D Print === | ||
| - | 3D Print the moldes using cura | + | {{:fabricademy2017:students:detoledomotta.naiadelara:untitled6.png?nolink&500x264}} |
| ==== :fabricademy2017:students:detoledomotta.naiadelara:untitled6.png?nolink&500x264 ==== | ==== :fabricademy2017:students:detoledomotta.naiadelara:untitled6.png?nolink&500x264 ==== | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International