Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
fabricademy2017:students:luis.dulanto:week13 [2018/07/22 20:30]
luis_dulanto
fabricademy2017:students:luis.dulanto:week13 [2018/07/22 20:40] (current)
luis_dulanto
Line 156: Line 156:
 So at this point, I got the design of the inflatable ready for being flattened. So at this point, I got the design of the inflatable ready for being flattened.
  
 +Then I loaded the model on SlicerForFusion360 (from Autodesk).
  
-<​grid>​ +selected ​folded ​panels ​and exported the pieces, first with tongues and with seams. The first one, was for creating a mockup, and the second one, was for getting the plastic pieces that were going to be joined for building ​the inflatable.
-<col sm="​1">​ </​col>​ +
-<col sm="​11">​ +
-{{:​fabricademy2017:​students:​luis.dulanto:​w13d1.png?​600}} +
-{{:​fabricademy2017:​students:​luis.dulanto:​w13d2.png?​600}} +
-{{:​fabricademy2017:​students:​luis.dulanto:​w13d3.png?​600}} +
-{{:​fabricademy2017:​students:​luis.dulanto:​w13d4.png?​600}} +
-</​col>​ +
-</​grid>​ +
- +
-Then loaded the model on Slicer. Selected ​folded ​pannels ​and exported the pices, first with tongues and with seams. The first one, was for creating a mock up, and the second one, was for getting the plastic pieces that were going to be joined for bulding ​the inflatable.+
  
 <​grid>​ <​grid>​