Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
fabricademy2017:students:luis.dulanto:week2 [2018/02/15 22:38] luis_dulanto |
fabricademy2017:students:luis.dulanto:week2 [2018/02/15 22:59] luis_dulanto |
||
---|---|---|---|
Line 317: | Line 317: | ||
{{:fabricademy2017:students:luis.dulanto:w2m81.png?300 }} | {{:fabricademy2017:students:luis.dulanto:w2m81.png?300 }} | ||
{{:fabricademy2017:students:luis.dulanto:w2m82.png?300 }} | {{:fabricademy2017:students:luis.dulanto:w2m82.png?300 }} | ||
+ | </col> | ||
+ | </grid> | ||
+ | |||
+ | For milling the pieces, I turned on the shopbot milling machine and the spinning tool, and fixed the MDF board to the machine witg some holders; After that, I clicked on reset on the techpendant and calibrated the machine at Z direction, this was done with a conductive plate and and scissors, and calibrated it in the XY plane, this was done atumatically by clicking on the calibrate XY button; then, I loaded the drilling toolpath on the shopbot software, for making the holes where I was going to put the screws that fixed the MDF board to the machine; I clicked on the start button and then clicked on start on the techpendant, once I did this the machine started to make the holes. So I used dose holes for fixing the board with screws and then I loaded the tootlpath of the smaller pieces to be milled and hitted on start at the software and once again I clicked start with the techpendant and repetated those steps until all the pieces where milled. | ||
+ | |||
+ | <grid> | ||
+ | <col sm="1"> </col> | ||
+ | <col sm="11"> | ||
{{:fabricademy2017:students:luis.dulanto:w2m83.png?300 }} | {{:fabricademy2017:students:luis.dulanto:w2m83.png?300 }} | ||
{{:fabricademy2017:students:luis.dulanto:w2m84.png?300 }} | {{:fabricademy2017:students:luis.dulanto:w2m84.png?300 }} | ||
Line 363: | Line 371: | ||
===== Building my own mannequin ===== | ===== Building my own mannequin ===== | ||
+ | For building my mannequin, I had to sand all the pieces and then with the aid of Alexandra, Carlos and my tutor I built the mannequin. | ||
<grid> | <grid> | ||
<col sm="1"> </col> | <col sm="1"> </col> |