Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
fabricademy2017:students:angela.barbour:week_08._open_source_hardware_-_from_fibers_to_fabrics [2018/02/13 19:44]
angelabarbour 		fabricademy2017:students:angela.barbour:week_08._open_source_hardware_-_from_fibers_to_fabrics [2018/02/17 20:07]
angelabarbour
Line 173: Line 173:
  ==== 08. Programing the controls in Arduino ====  ==== 08. Programing the controls in Arduino ====
  
 +Here is the final program in Arduino, to install the two motors: step and servo motors with their libraries.
  
 +Install the buttons to:
  
 +1. control the movement direction of step motor : CW or ACW
  
 +2. control the anglo of the pen with the servo motors: perpendicular to the paper (read to draw), or 30 degrees up 
 +(standby).
  
 +With this configuration the control of the draw is made by hand with the buttons.
 +I could after program in arduino the control to a automatic draw, and also use this machine to other purposes as controlling and moving a light system in my final project.
 +
 +
 +
 +
 +{{ :​fabricademy2017:​students:​angela.barbour:​hack01.jpg |}}
 +
 +
 + ==== 09. Video od all process _ Fabricademy Week08 Assignment ====
 +
 +
 +{{youtube>​yBQ0owVwL2k?​medium}}