Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
fabricademy2017:students:angela.barbour:week_11._soft_robotics [2018/02/20 22:22]
angelabarbour 		fabricademy2017:students:angela.barbour:week_11._soft_robotics [2018/02/20 23:03]
angelabarbour [Constructing a Soft Gripper]
Line 37: Line 37:
  
 https://​www.youtube.com/​watch?​v=uPx8xwRpfFk https://​www.youtube.com/​watch?​v=uPx8xwRpfFk
 +
 +{{youtube>​uPx8xwRpfFk?​medium}}
  
 https://​www.instructables.com/​id/​Soft-Robotic-Grabber-No-3D-Printer-Required/​ https://​www.instructables.com/​id/​Soft-Robotic-Grabber-No-3D-Printer-Required/​
Line 126: Line 128:
  
  
- == c. Joining the two pieces ​and installing the air system ​==+ == c. Unmold and Joining the two pieces ​ ==
  
  
Line 143: Line 145:
  
  
 + == d. Installing the air system and Testing ​ ==
 +
 +After everything is completlly dried, repair the edges, and cut the burrs, so the piece is as uniform us much as possible.
 +
 +Take a Plastic Botlle, of at least one liter and drill a hole with a nail in the cap, so you can insert the tube on it, seal with Hot Glue.
 +
 +In one side of the Gripper, between two legs insert the bulb gently until it reaches the air chamber, seal it with the silicone rubber.
 +
 +Wait everything dry and test pressing the bottle that will blow the gripper.
 +
 +{{ :​fabricademy2017:​students:​angela.barbour:​04_assembly.jpg |}}
 +
 +
 +
 + == e. Problems ==
 +
 +I have some problems, that were:
 +
 +1. The silicone I've found here in Brazil is not very elastic, so when I inflate the gripper to test and after I should still wrap each leg with the ribbon to more resistance and control of the movement, but as I said the silicone rubber produced, was too hard. 
 +
 +2. I've made a layer too thick above the air chamber, so it almost doesn'​t move with the air pressure.
 +
 +Pressing the air inside the botlle I can see some movement but not enough to move the gripper'​s legs.
 +
 +3. Than I've tried making another piece with less thickness above the air chamber and with less catalyzer to see if the silicone rubber would be more flexible, but at the end it doesn'​t polymerize very well and I couldn`t unmold perfectly the basis.
 +
 +So I'm trying to obtain another kind of silicone to make everything again.
 +
 +
 +{{ :​fabricademy2017:​students:​angela.barbour:​05_problems.jpg |}}